Bespoke Cutter And Tailor

Bespoke Professionals => The Coatmakers Forum => Topic started by: bobilishious on December 21, 2019, 02:05:36 AM

Title: Short jacket with side vents kicking - pattern help
Post by: bobilishious on December 21, 2019, 02:05:36 AM
My apologies if this is the wrong place to post.

Not a great deal if information to work with certainly but i've an existing gents short jacket pattern with a double vented back - i've attached an image of the pattern i'm using.

Front, chest, shoulders, around the arm all sit well but the vents are kicking terribly regardless of size. I was just wondering if anyone could see anything based simply from the attached - i'm thinking the angle of the side panel into the back is incorrect (as i think it's only angling in at around 3 degrees), what angle would you all typically work with?

Very much appreciate any assistance.

(https://i.postimg.cc/4m9mr4qS/pattern.jpg) (https://postimg.cc/4m9mr4qS)
Title: Re: Short jacket with side vents kicking - pattern help
Post by: peterle on December 21, 2019, 10:30:49 PM
Itīs hard to say without seeing the kicking vent. Your pattern lacks the chest, waist and hip line, so itīs difficult to interpret.
Wich angle do you mean? Can you mark it in the sketch? Usually pattern systems donīt work with angles. Does yourīs?

When you baste the vents closed for fitting, the issues and stressed lines will be more obvious.
Title: Re: Short jacket with side vents kicking - pattern help
Post by: Der Zuschneider on April 08, 2020, 07:36:31 AM
The curved hemline looks strange.
Title: Re: Short jacket with side vents kicking - pattern help
Post by: Hendrick on April 22, 2020, 06:59:01 AM

Was this traced from a finished garment? The flank part looks odd...